drip edge for a deck ledger

GAF EverGuard Standard Drip Edge Fascia Videos

This guide covers following procedures: Deck Preparation Base Ply Install Middle Ply Install Cap Sheet Installation Drip Edge Flashing and Accessory Installation details. Low slope areas such as the roofs of carports garages porches and sun rooms – anything below a 2/12 pitch requires special attention.

Get Price

Flashing a Deck Ledger Board Decks.com Decks.com by Seven Trust

How to Flash a Deck Ledger Board If you cut out your siding to install a ledger board careful steps must be taken to ensure that moisture cannot reach your house. Infiltrating rainwater can travel downward sideways and even upward so special flashings must be used.

Get Price

LP facia - drip edge around outside corner

Drip edge at the eaves is applied directly to the bare roof deck and the felt is installed so it laps over it--not like show in the photo above. Drip edge at the rakes should overlap the drip edge at the eaves and the felt installed over it.

Get Price

Amerimax Home Products 3 in. x 8 ft. White Galvanized Steel Deck Ledger

The Amerimax 8 ft. galvanized deck ledger flashing fits over deck ledger board and behind siding for protection from water damage. Painted galvanized steel features a baked-on factory finish. Use asphalt paper between metal and pressure-treated lumber.

Get Price

Deck Ledger Board Flashing - The Critical Concern

Afterwards you can use a wood block and a hammer to bend the flashing over the ledger board to form the drip edge. Use silicone caulking to seal the end butt joints and any places where water might intrude.

Get Price

How do you install drip edge on a deck?

The best way is to install the roof drip edge only along the eaves first then place ice-and-water barrier in the snowbelt or felt paper underlayment over the drip edge. Furthermore how do I attach a deck to siding? Slip flashing under siding Then slip flashing behind the siding covering the top edge of the ledger.

Get Price

Flashing a Deck Ledger Board on Vinyl Siding DIY Family Handyman

Then tack the ledger into place with 16d nails. Next slide drip flashing behind the vinyl so the lip fits over the top of the ledger as shown at right. Install undersill trim along the edge of the vinyl over the flashing at the top and bottom. Then lag-screw the ledger to the house using the fastener pattern approved in your plan.

Get Price

How to Attach Ledger Board For a Deck Decks.com Decks.com by Seven Trust

1. Carefully determine the height for the ledger—which will also be the height for all the joist framing. The top of the ledger board should be lower than the desired top of the finished deck by one decking board’s thickness plus the thickness of the flashing usually 1/8 inch . The finished deck height is 1 inch below the bottom of the sill.

Get Price

Deck Coatings: Drip Edge Flashing Deck Waterproofing Decking

Drip Edge Flashing Deck Coatings Drip Edge Flashing. If you want to secure the perimeter of your deck insuring a waterproof seal you must dial in the metal edges. Prestige Deck Coating knows how crucial properly installed flashing is to guarantee that your patio balcony or roof decks are waterproofed. Exterior Perimeter. For open decks with

Get Price

Amerimax Home Products 3-1/2 in. x 1-1/2 in. x 8 ft. Gray Deck Ledger

The 8 ft. gray plastic deck ledger flashing fits over deck ledger and behind siding for protection from water damage. It is recommended for use with pressure-treated lumber. This cap is made of durable plastic construction.

Get Price

Product Details

Product List